|
|
Stainless Steel davits that are truly "worry free".
|
Our
stainless dinghy davits are constructed from a single length
of 316 marine grade stainless steel. There are no rough edges,
no welds and no paint to fade, scratch or peel. They won't
pit or corrode around salt water like aluminum.
Our davits are only available factory direct so we can keep
our prices low, about a third to half that of the competitions
ordinary painted aluminum davits. |
 |
Simplicity
at it's best. Just push a button with an electric winch and
your dinghy will swing out a couple feet allowing easy access
through the transom door or all the way out to launch position.
Our stainless davits are easy to install. 85% of all installations
are done by the boats owner. They easily mount to your swim
step or transom. |
There are two sizes to choose from. Both davits are built
for dinghies 7 to 14 feet long with beams up to 6 feet wide.
(HD600) our Heavy Duty model is capable of loads to
600 lbs. $ 1,999.
(CD1200)our Commercial Duty capable of loads to 1,200
pounds. $ 2,499.
Both easily launch and retrieve all types of dinghies; even
most center consol and forward dash models. |
 |
Our
cantilever davits swing your dinghy out and away from the
stern to clear the swim step. The davit also makes a safe,
sturdy, handle to hold on to while getting in & out of your
dinghy. |
|
Both of our
stainless davits come with an electric winch. Hand Crank and
Block & Tackle winches are available by special request.
If you are
replacing an older davit system and already have a winch,
both of our stainless davits are available without winches.
The HD600 is available at $1,699 and the CD1200 is available
at $2,199.
We supply easy to follow instructions with every davit.
We also do factory installations. It's not necessary to
haul your boat for davit installation; all work can be performed
while your boat is in the water.
|
|
©
Marine Product Group, PO Box 2945, Port Angeles, Washington
98362 phone 1-360-457-1100
|
